Diamond Hard Coat 607 2:1 | 1.5L Kit Epoxy Resin
or 4 payments of $14.99 with
Info
Diamond Hard Coat 607 is a two-part clear epoxy resin that mixes 2 parts resin to 1 part hardener by volume. This 1.5L kit cures to a hard, high-gloss clear coat with enhanced resistance to UV discolouration, on canvas, timber, concrete and fibreglass. It also works for decoupage, as an adhesive and for filling shallow cavities.
Product details
Kit size
1.5L
Mix ratio
2:1 by volume
Working time
Approx. 30 minutes at 25 °C
Pour depth
1–2 mm per coat
Coverage
1 litre ≈ 1 m² at 1 mm
Set time
Approx. 1 day at 20 °C (1–2 mm)
Full cure
Approx. 3 days
Heat resistance
Up to 80 °C once cured
Key features
Enhanced UV resistance
Very low viscosity
Rapid bubble release
Low odour
Hard, high-gloss clear finish
2:1 mix ratio
What's in the 1.5L Kit
Part A
1L resin
Part B
500mL hardener
Coverage
≈ 1.5 m² at 1 mm
Best for
Canvas coating
Timber and tabletops
Concrete
Fibreglass laminating
Decoupage
Adhesive
Filling shallow cavities
How to use Diamond Hard Coat 607
1
Set up
Work between 20 °C and 30 °C. Raise your piece a few centimetres above the work surface so excess resin can run off.
2
Measure 2:1
Measure 2 parts resin (Part A) to 1 part hardener (Part B) by volume into a straight-sided mixing container.
3
Mix thoroughly
Mix for several minutes until the mix is evenly clear. For batches up to 16 litres, use a paint mixer on a drill at slow speed.
4
Pour
Pour onto your surface and let it flow over the edges. To tint, mix a larger batch and split it into smaller containers.
5
Release bubbles
Lightly pass a propane torch flame over the surface to help release bubbles.
6
Clean the edges
After about an hour, wipe or scrape any drips off the edges.
Pour 1–2 mm per coat. Build thicker finishes in layers.
FAQs
Safety & storage
Protection
Wear protective gloves and glasses when mixing and using. Always wear a mask when using any solvent cleaner.
Ventilation
Work in a well-ventilated area. Avoid contact with eyes and skin. Over-exposure may cause sensitisation.
Storage
Keep caps on bottles when not in use. Store at room temperature (approx. 18 °C), away from direct sunlight and not on concrete floors.
Clean-up
Clean tools and surfaces with orange citrus solvent, methylated spirits or a resin cleaner. If resin gets on your skin, wipe it off and wash with soap and water. Never use solvents on skin.
Diamond Hard Coat 607 2:1 | 1.5L Kit Epoxy Resin