Diamond Hard Coat 607 2:1 | 6L Kit Epoxy Resin
or 4 payments of $35.62 with
Info
Diamond Hard Coat 607 is a UV resistant clear epoxy resin, formulated for enhanced resistance to UV discolouration so your work stays clear. This 6L kit mixes 2:1 by volume and cures to a hard, high-gloss coat on timber and tabletops, canvas, concrete and fibreglass. Very low viscosity gives fast bubble release, with about 30 minutes of working time at 25 °C.
Product details
Kit size
6L
Mix ratio
2:1 by volume
Working time
Approx. 30 minutes at 25 °C
Pour depth
1–2 mm per coat
Coverage
1 litre ≈ 1 m² at 1 mm
Set time
Approx. 1 day at 20 °C (1–2 mm)
Full cure
Approx. 3 days
Heat resistance
Up to 80 °C once cured
Key features
Enhanced UV resistance
Very low viscosity
Rapid bubble release
Low odour
Hard, high-gloss clear finish
2:1 mix ratio
What's in the 6L Kit
Part A
4L resin
Part B
2L hardener
Coverage
≈ 6 m² at 1 mm
Best for
Canvas coating
Timber and tabletops
Concrete
Fibreglass laminating
Decoupage
Adhesive
Filling shallow cavities
How to use Diamond Hard Coat 607
1
Set up
Work between 20 °C and 30 °C. Raise your piece a few centimetres above the work surface so excess resin can run off.
2
Measure 2:1
Measure 2 parts resin (Part A) to 1 part hardener (Part B) by volume into a straight-sided mixing container.
3
Mix thoroughly
Mix for several minutes until the mix is evenly clear. For batches up to 16 litres, use a paint mixer on a drill at slow speed.
4
Pour
Pour onto your surface and let it flow over the edges. To tint, mix a larger batch and split it into smaller containers.
5
Release bubbles
Lightly pass a propane torch flame over the surface to help release bubbles.
6
Clean the edges
After about an hour, wipe or scrape any drips off the edges.
Pour 1–2 mm per coat. Build thicker finishes in layers.
FAQs
Safety & storage
Protection
Wear protective gloves and glasses when mixing and using. Always wear a mask when using any solvent cleaner.
Ventilation
Work in a well-ventilated area. Avoid contact with eyes and skin. Over-exposure may cause sensitisation.
Storage
Keep caps on bottles when not in use. Store at room temperature (approx. 18 °C), away from direct sunlight and not on concrete floors.
Clean-up
Clean tools and surfaces with orange citrus solvent, methylated spirits or a resin cleaner. If resin gets on your skin, wipe it off and wash with soap and water. Never use solvents on skin.
Diamond Hard Coat 607 2:1 | 6L Kit Epoxy Resin