Silicone Rubber 1:1 Mould Maker | 1L Kit
or 4 payments of $10.49 with
Info
Silicone Rubber 1:1 Mould Maker | 1L Kit
Kit Includes:
1 x 500mL Part A Bottle
1 x 500mL Part B Bottle
Suitable for making delicate intricate impression moulds, masks, soap moulds, candle molds. Ideal for fine detailed moulds used in conjuncton with Solid Cast 660 Polyurethane for producing plastic models, figurines, jewellery and prototype parts.
Silicone Rubber is suited to small to larger moulding and casting work used in conjunction with concrete or plaster to produce figurines, garden ware and precast building elements.
Platinum Cure Silicone ✔
Impression Moulds ✔ Soap Moulds ✔ Candle Moulds ✔ Jewellery & Prototype Parts ✔
- Mixing Ratio 1:1 by Volume
- 20 - 30 min pot life
- Low Viscosity
- Shore Hardness 30A
- 2 Hour Cure Time
- Food Grade Non - Toxic
Temperature Resistance – up to 220 degrees Celsius
COVERAGE:
1 Combined litre, 500ml Part A & 500ml Part B will cover approximately 1 sq mtr @ 1mm Depth
DIRECTIONS:
1 part A to 1 part B by volume. Mix thoroughly in a straight sided, flat bottomed container. Do not mix in an ice cream container. Use a flat ruler shaped mixing stick. Mix well scraping around the sides and base of the container.
Demoulding in around 2 to 4 hours @ 25 degrees. Low shrinkage on large scale moulds. If mould is adhesive after 24 hours this is due to temperature been too cold. You can fix this by placing mould in a hot room @ 25 degrees or wait 3 - 5 days and this will go away.
TIP:
It is recommended when pouring large casting moulds to set silicone for at least 12 hours before demoulding.
TECHNICAL DATA:
Colour: Pink
Shore Hardness: 30A
Tensile Strength: (MPa) 4.5
Elongation %: 550%
Tear Strength (kN/m): 25
Viscosity A/B Mixed Mpa.s: 7000
SAFETY DIRECTIONS:
Work in a well-ventilated area. Avoid contact with eyes and skin. Wear protective gloves and glasses when mixing and using. Over-exposure may cause sensitization. Uncured material can be removed with a solvent or methylated spirit followed by washing
with warm soapy water. Always wear a mask when using any solvent cleaner.
| Curing temp 25°C |
| Shore Hardness 30A |
| Cure 2 hrs @ 25 degrees |
Customer Reviews
Silicone Rubber 1:1 Mould Maker | 1L Kit
I have used the 1:1 Mould Maker kits to make silicone moulds for soft plastic lures. It is extremely durable and can withstand the heat of the plastisol for these lures. Great product.
Used for making resin inlays so needed to set thin but be tear resistant, works very well for this, picks up the smallest detail, holds mica powder to it's surface for the inlays and comes out clean when removed from the final product.
I needed a mould for making a non structural, trim fitting for a car. This product worked really well for my application, have purchased more as a result.
This worked perfectly and was easy to use. I will definetly buy again.
It did exactly what I had hoped, so I am very happy indeed. The 5 stars are the rating I will give you.